Changes between Version 1 and Version 2 of cv4400

Timestamp:

2013-09-19T10:30:35-04:00 (12 years ago)

Author:

warb

Comment:

--

cv4400

@@ -52 +52 @@
         </CDRADAR>
 
+}}}
+
 {{{
    <Site
@@ -60 +62 @@
             CV4400_SCAN_TIME="4618"
             CV4400_TO_LAN="ENABLED">
-        </Site>
+   </Site>
 }}}
 
-}}}
 
 '''PROTOCOL="ASR9_RADAR"'''
@@ -96 +97 @@
 send data in conformance with MIL-STD-188.
 }}}
+
+
+'''CV4400="ENABLED"'''
+{{{
+This adaptation parameter is the main toggle for selecting whether the incoming radar data (for a given
+radar) is to be processed by the CV4400 filtering/formatting function in ECG. The default for ECG CV4400
+is DISABLED. If ECG CV4400 filtering is desired, then this parameter must be changed to ENABLED
+
+When the ECG CV4400 filter is enabled, additional subparameters must also be set to support the ECG
+filtering/formatting functionality. The adaptation specialist that is setting up the adaptation for a given site
+must have access to the configuration data sheet for the short-range radar to be adapted. The data sheet
+facilitates selection of the appropriate values for CV4400–related parameters within the ECG SCT. Most
+of the other parameters discussed in subsequent subsections address how data from one message type
+(i.e., ASR–9) is to be converted for CD2 output (full-scan or skip-scan, depending on adaptation).
+If CD2 output is not desired, the ECG CV4400 parameter is left DISABLED. The output to
+HCS/ECG/DARC is whatever the radar site is sending. (Host must receive CD2 skip-scan format data
+from short-range [ASR] radar).
+
+}}}
+
+'''CV4400_SKIP_SCAN'''
+''Note: The example <Site> element does not contain this parameter, so the default will be applied i.e. no skip scan. A sepadapt supporting host (HCS) would need this ENABLED''''''''
+{{{
+This parameter is used to enable or disable the ECG CV4400 filter that performs removal of every other
+scan of incoming radar.
+The CV4400_SKIP_SCAN parameter is disabled as the default and is set appropriately for the desired
+output to Host/ECG/DARC. If the CV4400 parameter is enabled and the CV4400_SKIP_SCAN parameter
+is enabled, then Host/ECG/DARC receives the CD2 skip-scan format data it requires. 
+}}}
+
+'''CV4400_TO_LAN="ENABLED"'''
+{{{
+This parameter is used to enable or disable the multicasting of radar data after the radar data has been pro-
+cessed (by) the CV4400 filtering/formatting function in ECG. This parameter should be enabled for ECG/DARC
+when it is desired to send short-range radar data (that has been processed by the ECG CV4400 con-
+version software) to the multicast for the DARC and RAPPI clients to receive. The default is DISABLED.
+}}}